Archive for May, 2007

Fake Supervision

Wednesday, May 30th, 2007

If your telco does not provide far end disconnect supervision or if they just dont do it well you may need to “fake” supervision in order for your lines to disconnect properly. You may fake supervision by adding a few lines to your zapata.conf .

Add the following to your /etc/asterisk/zapata.conf

callprogress=yes
busydetect=yes

After doing this restart asterisk. There may still be a disconnect delay but it will be reduced.

trixbox CE 2.2 Login/Registration Workarounds

Wednesday, May 30th, 2007

It has been brought to our attention that the scripts that do the registration pop-up and the package manager login can be finicky and still give you issues weather you have registered or not. There are ways to remove these annoyances. Fonality probably has a reason to collect the information so a standard disclaimer, only use this information for good and only as a last resort.

(more…)

Load Rhino T1 card as an E1 card

Tuesday, May 29th, 2007

Below is the instructions from our PCI manual on configuring your rhino T1 as an E1. You will use the appropriate insmod command as apposed to modprobe.

(more…)

Trixbox 1.2.3

Wednesday, May 23rd, 2007

We have been seeing random stability issues with TB 2.2 If you would like to downgrade to the last known stable version of Trixbox you may download Trixbox 1.2.3 from there SF project page.

(more…)

Ceros Recovery Disk

Tuesday, May 22nd, 2007

If you for whatever reason need to reinstall your Ceros system you may use the image below. (more…)

Oneway Audio on R4FXO after TB 2.2 Upgrade

Monday, May 21st, 2007

If you have a R4FXO-EX or R4FXO-EC and have upgraded to the RPM version of our drivers or if you use our new driver method and your card stops working you may need to upgrade your hardware.

(more…)

ZAP Caller Id Issues

Monday, May 21st, 2007

Some users have reported issues with the display of caller ID data. This post contains recommendations found in lab testing which may increase the probability of success.

(more…)

Rhino PCI Card Driver Install

Monday, May 21st, 2007

There are a few ways to install our pci drivers, no matter which method you choose you only need to do it once for all Rhino cards including legacy cards. This means if you have followed these steps once and are simply adding a new card, no further software installation is needed.

(more…)